Shrouds and Spreaders

Posted By: Jay Brumberg
Date: 9/21/08 11:51a.m.

Report: outside forum guidelines

In Response To: shrouds (duane)

duane: I took a picture of how I set up my shrouds. The picture is not as close uup as I would have liked. To summarize: On my spreaders ther is a little hole inward of the shroud notch . I run a piece of stainless steel seizing wire through this hole with equal lengths of wire above and below the spreader. I then wind the seizing wire around the shroud above and below. Then I wrap the shroud/spreader area with self adhesive wrapping tape. Then I cover this with my spreader boots. I wind the wire pretty tight, but not so tight that it wont slide in the notch a little bit. The same applies to the tape and boot. I hope this helps. Jay