Trailer Sailor Discussion Forum

Forestay Hound

Posted By: Bob Frak
Date: 5/18/08 6:30p.m.

Report: outside forum guidelines

OK, my project pales by comparison to Gary's but my tank time is coming also. If you remember my bent 5/16' forestay fitting bolt from last fall, I fixed it today. I know some of you have put a sleeve over the bolt but I chose to install a hound. The hound came from Rig Rite part # K405 47 @ $69.00 ($40 over what I thought it was worth but....) I had to squeeze it together slightly but it fit the profile almost perfectly. I first marked the mast where the original tang hole was for the forestay. Then I positioned the hound so I could use the original through holes. Used a screwdriver on each side through the 5/16" holes to pull it down into position. Then pop riveted it from the tang end to the through hole, alternating from side to side. Then I had to drill out the hole slightly, 1/3 of the original was covered. Then I shortened and drilled the original tang to position the hole for the roller furler in the original position. Bob Frak S/Y Alegira

Messages In This Thread

Forestay Hound -- Bob Frak -- 5/18/08 6:30p.m.

Bent bolt -- Bob Frak -- 5/18/08 6:31p.m.

How thick is the hound metal and... -- Tom Cannon, 2023A, Coupeville WA -- 5/19/08 6:49a.m.

As you know, I used a "crush washer"... -- George E Norkus, Santana 2023A, SE Michigan -- 5/19/08 5:13p.m.

Close -- Bob Frak -- 5/20/08 7:37p.m.

Post Response

Your Name:
Your Email Address:
Subject:

Click here for help on smiley faces and formatting codes If you'd like to include a link to another page with your message, please provide both the URL address and the title of the page:
Optional Link URL:
Optional Link Title:
If you'd like to include an image (picture) with your message, please provide the URL address of the image file: You may upload a file to our server by clicking here.
Optional Image URL:
If necessary, enter your password below:
Password:

Santana/Schock Forum is maintained by SailboatOwners.com with WebBBS 5.12.